Galaxy S23 and S23+: images show design of Samsung phones

O Samsung Galaxy S23 and S23+ were registered for 3C certification in China, which opened the door for the first unofficial information about the devices. Some features about the devices have been leaked and show design changes from the S22+.

From a rendering performed by the website SmartPrix and the OnLeaks twitter profile, it is possible to check the details of the new line of smartphones from the South Korean. Check out below what the S23 and S23+ should look like, which are supposed to be released in the first quarter of 2023.

The document states that the Galaxy S23+ will have similar dimensions to the S22 Plus. While the new model measures 157.7 x 76.1 x 7.6 mm and offers a 6.6-inch screen, the previous version measures 157.4 x 75.8 x 7.6 mm with a screen of the same size.

exterior design

(Source: SmartPrix/OnLeaks/Reproduction)(Source: SmartPrix/OnLeaks/Reproduction)Source: SmartPrix/OnLeaks/Reproduction

According to the images produced, the Galaxy S23 will have a triple vertical camera in the upper left corner and a perforated screen in the center of the lower corner. Unlike the S22, there is no separate camera island. But each camera has protruding rings, just like the S22 Ultra.

Apparently, the SIM card slot will be on the bottom edge, where there is also a USB-C port and the speaker. On the right side, the power key and volume buttons are present.

inside the cell phone

The certification information in China does not provide details about the Galaxy S23’s internal hardware. However, rumors around the S23+ point to a Snapdragon 8 Gen 2 processor. This would be the only big change from the S22, as the other internal components wouldn’t be much different from the predecessor version.

Source link

About Admin

Check Also

Three Cryptocurrency Billionaires Dead in 30 Days and a Mystery in the Air

Written in GLOBAL he 11/30/2022 · 7:07 pm A helicopter from the air taxi company …

Leave a Reply

Your email address will not be published. Required fields are marked *